I had to pull the motor out for a major overhaul. I am sure I have misspalced a ton of bolts in the process. I sent out the cam shafts to get them grind-ed to the 264 package by Schneider Racing Cams. Then I sent off the Cam Gears to Russ with z31parts. Doing so will help with the small upgrade with the head with my fuel management system being switched to an analog system.
I have so far pulled the motor, cleaned up the engine bay, and did a full re-ring kit on the pistons. All the races and bearing was solid and clean and still to spec so they where not needing to be replaced.
Next is I cleaned up the block some I had to clean up a lot of grim and dirt that built up over time. I am now in the process of putting the motor back in, cleaning up the heads to accommodate the shiny cam gears.
